Banger 1.0

           Banger 1.0

Banger 1.0 is a obstacle race completer robot which can handle all obstacles, no matter it is based on sand, water or a rough surface. Banger 1.0 is a wired remote controlled robot which is based on pollulo motors which after a few experiments were found to be the most stable. Although it is not quite good at speed it gives a good competition in a obstacle race and focuses on the main objective of the obstacle race- completing the race without hampering the obstacles and without damaging them.

 Banger 1.0

Quick Description

Banger 1.0 is a small but task accomplished robot which using the benefit of being small can easliy climb on obstacles- like sloping bridge the best of all! But that's not just what Banger 1.0 is capable of . Due to the small motors it can easily climb a slope even though the surface below is on sand, water or is rough. Down posted below is a sample video what our robot is capable of!

Test in a Competition ( Vigyantram competition conducted in IIT Bombay)

Here's a video on the working on Banger 1.0 in the Vigyantram competition

Requirements

• 4 Pollulo Motors
• 4 DTDP Switch
• Jumper Wires
• Battery Snap
• Battery(HIW Company 9 volts)
• Long wire to connect Remote to Robot

DTDP Switch Connections

Pollulo Motor Connections

For the connections, you have to connect two motors together, like you have to solder one terminal from both motors on one side into one wire which will connect to the DTDP switch of our remote, Similarly the pollulo motors will be connected on the other side. So this ends you with a wired remote controlled robot which can move in all directions - forward, backward, sharp left, sharp right, one wheel right turn, one wheel left turn.

Remote

Battery

Hope You guys like the tutorial.... Please subscribe to my Youtube channel ( Circuit Creator) and #stay tuned for the next versions of Banger, Banger 2.0 (Joystick controlled Robot), Banger 3.0( Mobile controlled Robot), and Banger 4.0( Line Follower Robot).